Edge Cut

Last updated on May 17, 2022

Use Edge Cut tool to add extra geometry to the SubD surface.

Access and Use

  1. Open the SubD Tools Menu
  1. Grab the Edge Cut and use trigger on your drawing hand to add extra geometry point to the surface geometry
  1. To complete the command, hover over to where you want the second point of the extra geometry and press the trigger on your drawing hand again
  1. The extra geometry has been added to the surface geometry
  1. Select the blue check mark to finish editing
💡
Tip: Use this tool to make cutlines in products/cars.
Did this answer your question?
😞
😐
🤩