Use creasing to apply crease on a SubD surface.
Access and Use
- Grab the Crease tool and point it on the surface geometry
- Pull the front trigger on the same controller to apply crease

4. Click the blue tick mark button on your non-drawing hand to finish editing
Add crease to the entire loop
You can add crease to an entire loop by pulling the front trigger on a non-drawing hand while selecting a loop to crease.
Remove Crease
To remove the crease from the surface repeat the process and select the creased geometry with the tip of the Crease tool again.

Comments
0 comments
Please sign in to leave a comment.